[teqc] ublox to rinex
lou at unavco.org
Wed Jul 19 14:26:49 MDT 2006
> Last summer, I collected data with a GPS receiver from u-blox. I recorded more
> information than teqc needs to convert my ubx to RINEX. When, I use teqc there
> are a lot of messages like:
> ! Notice ! u-blox message class/id 0x0211 unknown or not coded yet ? skipping.
> Teqc translate just a part of my file and close. The size of my ubx file is
> 40912 Ko.
> Can you help me about that?
Well, UBX 0x02 0x11 is the RXM-SFRB (subframe buffer) message, holding
the raw transmitted navigation messages from GPS or SBAS SVs. The only
thing this would not give you are any navigation messages contained
in these UBX messages. _There is no impact on observations._ UBX 0x02 0x11
wasn't coded up because I never received a UBX file with these messages;
instead teqc reads the uncoded GPS nav messages in UBX 0x02 0x31 == RXM-EPH.
Louis H. Estey, Ph.D. office: [+001] 303-381-7456
UNAVCO, 6350 Nautilus Drive FAX: [+001] 303-381-7451
Boulder, CO 80301-5554 e-mail: lou unavco.org
WWW: http://www.unavco.org http://jules.unavco.org
"If the universe is the answer, what is the question?"
-- Leon Lederman
More information about the teqc