[teqc] C2 and P2

[Lou Estey]

Wesley,

> I am studying about the GPS modernization. When exists two observed
> P2 and C2 in file, the TEQC it calculates MP2 with which observation?

Teqc uses the precise code, if it is available, over the course acquisition
code.  Thus P2 is used if available, as is P1 over C1.

> There is some option to select only a observation?  

No 1-step option, but it is easy enough to do with existing options.
First, qc the full file, which I'm going to assume has P1 and P2, and
thus the multipath will be done with P1 and P2.  Then create an "edited"
RINEX observation file with -O.obs:

teqc +C2 -O.obs l1+l2+c1+c2 RINEX_CP > RINEX_C

and then qc the RINEX_C file with just C1 and C2, and then the multipath
will be done with C1 and C2.

cheers,
--lou

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Louis H. Estey, Ph.D.              office:  [+001] 303-381-7456
UNAVCO, 6350 Nautilus Drive           FAX:  [+001] 303-381-7451
Boulder, CO  80301-5554            e-mail:  lou  unavco.org
    WWW:  http://www.unavco.org   http://jules.unavco.org

"If the universe is the answer, what is the question?"
                                                -- Leon Lederman
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~