[teqc] Trimble T02/Dat to Rinex Conversions

[Kerry Matthews]

Hi Lou,

 

Same T02 file in all cases

 

T02 file to Rinex using ConvertToRinex (2.02.0) appears ok but processes
high (~75mm)? Rinex antenna height 0.0, Using NGS absolute calibration data.


T02 file to Dat (Trimble Data Transfer utility) then to Rinex using Dat2Rin
(v3.50). Rinex antenna height -0.0692 (processes even higher of course)

T02 file to Dat (Trimble Data Transfer utility) then to Rinex using TEQC
(2010Mar17). TEQC gives a warning GPS week is 0 (not 1600) and results in
Approx Position XYZ as 0,0,0 ??

 

So what is TEQC trying to tell me?

 

Also are these Trimble conversions making adjustments with regard phase
offsets, antenna heights relative to ARP etc. Receiver is an R8 GNSS Model 3

 

Also file is Static/Kinematic and only the ConvertToRinex utility appears to
convert this as expected? 

 

Regards,

 

Kerry Matthews   

 

 

IMPORTANT NOTICE - This message may contain private and confidential
information, the contents of which, and/or any attachments to this message
including e-mail address may be the property of the sender, which shall not
be copied, disseminated or used for any purpose without prior and specific
permission to do so. If this has been received in error please notify the
above contact.

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://ls.unavco.org/pipermail/teqc/attachments/20100911/de600c77/attachment.html