[teqc] option '-O.sum .' doesn't work on Ashtech B-file

Lou Estey lou at unavco.org
Thu Dec 9 13:52:59 MST 2010

Ah, it works if you supply the observable list that you want to summarize,

teqc -O.obs l1+l2+c1+p1+p2 -O.sum . B445ZA09.186

works just fine.  The "problem" is that there is not an early default
observable list for an arbitrary B-file; teqc establishes a
default observable list later once it's opened up the B-file a bit.

So you might run into the same problem using '-O.sum .' for another
format.  If so, just supply an observable list using the '-O.obs' option.

I'll try to figure out a sensible failover if using '-O.sum .'.


On 12/9/2010 11:35 AM, Lou Estey wrote:
> Just discovered by me while modernizing teqc's reading of Ashtech B-file
> format: using '-O.sum .' on a B-file doesn't work, e.g.
> teqc -ash d -O.sum . B445ZA09.186
> Doesn't crash and burn, but it exits early with a strange set of
> messages.
> This is the first format I've run into where '-O.sum .' doesn't work.
> --lou
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Louis H. Estey, Ph.D. office: [+001] 303-381-7456
> UNAVCO, 6350 Nautilus Drive FAX: [+001] 303-381-7451
> Boulder, CO 80301-5554 e-mail: lou unavco.org
> WWW: http://www.unavco.org http://jules.unavco.org
> "If the universe is the answer, what is the question?"
> -- Leon Lederman
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

More information about the teqc mailing list